Waterworks Ludlow Pressure Balance Control Valve Trim with Me User Manual

Browse online or download User Manual for Accessories for water Waterworks Ludlow Pressure Balance Control Valve Trim with Me. Waterworks Ludlow Pressure Balance Control Valve Trim with Metal Lever Handle User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 3
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
LUDLOW
Pressure Balance Control Valve Trim
INSTALLATION GUIDELINES
Page 1 of 3
10.30.2013
These guidelines have been prepared for the professional contractor to aid in the installation of:
LUDLOW PRESSURE BALANCE TRIM WITH LEVER HANDLE (STYLE# LDPB10)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
Metal Lever Handle
Style No. LDPB10
SPECIFICATIONS:
Rough-in Depth Minimum: 2-1/8"
Rough-in Depth Maximum: 2-7/8"
Integrated Diverter: No
REQUIRED PLUMBING DETAILS:
Universal Pressure Balance Valve
STYLE # GUPB81
IMPORTANT:
¾ NOTE: The screws on the trim plate are aesthetic
and do not serve any mechanical purposes and
should not be removed.
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ This product is intended to work with the
Waterworks Universal Pressure Balance Valve (Style
# GUPB81). The risk of scalding exists until the
installer has properly calibrated/adjusted the
temperature setting during final trim installation.
¾ The bottom outlet of the GUPB81 is intended for use
with a diverter tub spout only, when used for
tub/shower combo.
¾ Do not use Pex piping from the valve to the tub
spout. This will cause too much back pressure for
the valve to function properly.
¾ Be sure your installation conforms to federal state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor.
¾ Refer to the specifications and assembly drawings
attached. Product is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ This product must be on-site prior to rough-in which
allows the installer to visualize the installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ The use of certain plumber's putty may stain stone
or tile surfaces.
VALVE OPERATION:
¾ See Figure 1. for Steps 1-3.
1. When the finished wall is complete, turn on the hot
and cold supplies and pull off the tile guard. Valve
will not operate unless BOTH supplies are turned on.
2. The lever handle is for controlling the temperature
only, not volume. Place the handle on the valve stem
so it rests at 6 o'clock in the OFF position and then
turn the handle counter clockwise through the cold,
then warm and stopping at the hot position. If
additional rotational friction is required to maintain
the handle position, tighten the packing nut.
3. Allow the valve to run in the warm position for a few
minutes to completely flush the system. If system is
quite dirty, remove valve spindle to ensure proper
flushing. Refer to the Installation Guidelines for the
Pressure Balance Valve which contains a complete
parts breakdown and related information.
Figure 1
Valve Spindle
Plastic Washer
Bonnet
Finished Wall
Packing Nut
Page view 0
1 2 3

Summary of Contents

Page 1 - INSTALLATION GUIDELINES

LUDLOW Pressure Balance Control Valve Trim INSTALLATION GUIDELINES Page 1 of 3 10.30.2013 These guidelines have been prepared for the professio

Page 2

LUDLOW Pressure Balance Control Valve Trim INSTALLATION GUIDELINES Page 2 of 3 10.30.2013 These guidelines have been prepared for the professio

Page 3

LUDLOW Pressure Balance Control Valve Trim INSTALLATION GUIDELINES Page 3 of 3 10.30.2013 These guidelines have been prepared for the professio

Comments to this Manuals

No comments