Waterworks Ludlow Pressure Balance with Diverter Trim with Me User Manual download pdf

LUDLOW

Pressure Balance with Diverter Trim

INSTALLATION GUIDELINES

Page 1 of 3

10.30.2013

These guidelines have been prepared for the professional contractor to aid in the installation of:

LUDLOW PRESSURE BALANCE TRIM WITH LEVER HANDLE WITH DIVERTER (STYLE# LDPB30)

All dimensions are based on original specification and are subject to change and variation.

Please consult your Design Associate for current specifications.

Metal Lever Handle

Style No. LDPB30

SPECIFICATIONS:

Rough-in Depth Minimum: 2-1/8"

Rough-in Depth Maximum: 2-7/8"

Integrated Diverter: Yes

REQUIRED PLUMBING DETAILS:

Universal Pressure Balance with Diverter Valve

STYLE # GUPB87

IMPORTANT:

¾ NOTE: The screws on the trim plate are aesthetic

and do not serve any mechanical purposes and

should not be removed.

¾ To ensure this product is installed properly, you

must read and follow these guidelines.

¾ The owner/user of this product must keep this

information for future reference.

¾ This product is intended to work with the

Waterworks Universal Pressure Balance with

Diverter Valve (Style # GUPB87). The risk of

scalding exists until the installer has properly

calibrated/adjusted the temperature setting during

final trim installation.

¾ The bottom outlet of the GUPB87 is intended for use

with a tub spout only. The use of any fitting with a

restricted flow, such as a handshower, will cause the

diverter to not function properly.

¾ Do not use Pex piping from the valve to the tub

spout. This will cause too much back pressure for

the valve to function properly.

¾ Be sure your installation conforms to federal state,

and local codes. In the State of Massachusetts, all

installations must comply with the rules and

regulations set forth within 248 CMR.

¾ This product must be installed by a professional

licensed contractor.

¾ Refer to the specifications and assembly drawings

attached. Product is sold partially assembled but

shown fully disassembled for illustrative and service

purposes only.

¾ Inspect this product to ensure you have all the parts

required for proper installation.

¾ This product must be on-site prior to rough-in which

allows the installer to visualize the installation.

¾ Use only a strap wrench or protected/smooth-jaw

wrench on any finished surface.

¾ The use of certain plumber's putty may stain stone

or tile surfaces.

VALVE OPERATION:

¾ See Figure 1. for Steps 1-3.

1. When the finished wall is complete, turn on the hot

and cold supplies and pull off the tile guard. Valve

will not operate unless BOTH supplies are turned on.

2. The lever handle is for controlling the temperature

only, not volume. Place the handle on the valve stem

so it rests at 6 o'clock in the OFF position and then

turn the handle counter clockwise through the cold,

then warm and stopping at the hot position. If

additional rotational friction is required to maintain

the handle position, tighten the packing nut.

3. Allow the valve to run in the warm position for a few

minutes to completely flush the system. If system is

quite dirty, remove valve spindle to ensure proper

flushing. Refer to the Installation Guidelines for the

Pressure Balance Valve which contains a complete

parts breakdown and related information.

Figure 1

Valve Spindle

Plastic Washer

Bonnet

Finished Wall

Packing Nut

1 2 3

INSTALLATION GUIDELINES 1

Summary of Contents

Page 1 - INSTALLATION GUIDELINES

LUDLOW Pressure Balance with Diverter Trim INSTALLATION GUIDELINES Page 1 of 3 10.30.2013 These guidelines have been prepared for the professio

Page 2

LUDLOW Pressure Balance with Diverter Trim INSTALLATION GUIDELINES Page 2 of 3 10.30.2013 These guidelines have been prepared for the professio

Page 3

LUDLOW Pressure Balance with Diverter Trim INSTALLATION GUIDELINES Page 3 of 3 10.30.2013 These guidelines have been prepared for the professio

Comments to this Manuals

No comments

Waterworks Ludlow Pressure Balance with Diverter Trim with Me User Manual

Browse online or download User Manual for Accessories for water Waterworks Ludlow Pressure Balance with Diverter Trim with Me. Waterworks Ludlow Pressure Balance with Diverter Trim with Metal Lever Handle User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Accessories for water Waterworks Ludlow Pressure Balance with Diverter Trim with Me